ASTM B(). Standard Specification for Nickel Plate, Sheet, and Strip. standard by ASTM International, 10/01/ View all product details. Manufacturer & suppliers of Nickel / ASTM B Plate Aesteiron Steels leading Nickel / ASTM B Plate manufacturers, founded in Buy ASTM B() Standard Specification for Nickel Plate, Sheet, and Strip from SAI Global.
|Published (Last):||25 February 2008|
|PDF File Size:||8.43 Mb|
|ePub File Size:||6.75 Mb|
|Price:||Free* [*Free Regsitration Required]|
In plate products, this can be achieved by controlling the finishing temperature in hot rolling and the elimination asmt the anneal that follows hot rolling.
These sheets are made by rolling process. Siddhagiri B16 and Tubes Rating: Siddhagiri Metals and Tubes Manufacturer: It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. Cutting is used to separate large sheets into smaller pieces, to cut out a part perimeter, or to make holes cavities in a part.
Test methods chemical analysis, mechanical test, grain aastm test shall be performed in accordance to referenced ASTM documents itemized herein. AlloyAlloy Brand: Link to Active This link will always route to the current Active version of the standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
ASTM B – 93ae1 Standard Specification for Nickel Plate, Sheet, and Strip
Also Each flat rolled product owes its final properties not just in the rolling process itself but to its vital interactions with the preparatory steps of alloying, casting, scalping and pre-heating; intermediate annealing; and such later finishing steps as a solution heat treatment or final annealing, stretching, leveling, slitting, edge trimming and aging. The material shall be uniform in quality and temper, smooth, commercially straight or flat, and free of injurious imperfections.
The material shall conform to the chemical requirements for nickel, copper, iron, manganese, carbon, silicon, and sulfur. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Looking for some more information? Offer on Fasteners Sitemap.
Nickel 200® & Nickel 201®
Historical Version s – view previous versions of standard. Sheet metal parts are characterized by high strength, good dimensional tolerances, good surface finish, and relatively low cost.
Sheet and Strip can be cold rolled to higher strength. Deep drawing is a manufacturing process that is used extensively in the forming sstm sheet metal under tensile and compressive conditions, without altering the sheet thickness.
The material shall conform to the mechanical property requirements for tensile strength, yield strength, elongation, and Rockwell hardness.
ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. For deep drawing and spinning quality sheet and strip, the material shall conform to specified values for grain size and hardness properties.
This abstract is a brief summary of the referenced standard.