INIC Initio Corporation. 1. INIC USB to SATA Bridge. Specification. Version August 10, Initio Corporation. INIC initio datasheet pdf data sheet FREE Datasheets (data sheet) search for integrated circuits (ic), semiconductors and other electronic components such . inic, USB to SATA Bridge Overview The INIC provides an advanced solution to connect SATA devices to w,

Author: Salar Shaktigami
Country: Bhutan
Language: English (Spanish)
Genre: Science
Published (Last): 26 July 2014
Pages: 303
PDF File Size: 13.74 Mb
ePub File Size: 20.47 Mb
ISBN: 588-1-92018-793-2
Downloads: 48257
Price: Free* [*Free Regsitration Required]
Uploader: Neshura

Are these flashable using some kind of serial or TTL interface to the drive itself?

My gut feeling is that the drive locks up or begins misbehaving when trying to access some particular LBA possibly outside the normal accessible region, i. They are incredibly complicated, precision devices.

If the answer to 2 is “no, nothing’s available right now”, does anyone have inic-168 further explaining the problem described here, section “Managing Firmware Problems”? Regards and good luck!


I’ll need to swap U12 easy and U14 hard; damn surface mount stuff is so tiny! All of this is so incredibly frustrating. ASME and buy your own drive. Drive spins up 3. Maybe a hardware based cloning tool might help as it will send soft-reset, hard-reset and power off-on the drive as needed. You do not have the required permissions to view the files attached to this post.

Can handle the decryption on those drives without any problem at all. This is because of some issues on some firmware of Inic1608 drives not dealing with sectors that are pending relocation properly.

Access LED goes steady again 6. You can’t write to the firmware by TTL. You need proper tools. Assuming the drive is detected as it should to start with.

INIC-1607E, INIC-1608L, INIC1610

So it’s a different issue. But that U14 chip So I’m his best bet, barring physical damage. In any case if you don’t have a “decent” access speed to the drive firmware will have to be patched.


Try cloning the drive with ddrescue. U14 deals with USB bridge aspects as encryption Is this procedure documented? Sounds like a directory problem, or bad sector 0, or possibly a firmware issue. Newbie info, from and for newbies. Your original board is You simply don’t have the knowledge, equipment, or experience to pull this off. I’m referring to the process described here: Switch to full style. So drive cloning or similar things dd, etc.

After about 45 full seconds or so, 4 happens, rinse lather repeat Access LED goes steady again 7. You can buy PCBs out of ebay.

Free initio inic l Download – initio inic l for Windows

Access LED is steady for about half a second 2. The access LED interval also sometimes varies. A continuation of 2: