INTERSEAL HS – PART B (REGULAR) – L () Use; Colors; MSDS / TDS; Variant; Product Review(s). Use For immersion service, Interseal HS must be applied to surfaces blast cleaned to SSPC-SP10 or Sa PT. International Paint Indonesia. Safety Data Sheet EGA INTERSEAL HS GREY PART A Version Number 2 Revision Date 06/27/ 1. Product and . International Paint Ltd. Safety Data Sheet. EGA Interseal HS Grey Part A. Version No. 2 Date Last Revised 05/10/ Conforms to the requirements of.

Author: Sanris Tok
Country: Grenada
Language: English (Spanish)
Genre: Education
Published (Last): 21 November 2016
Pages: 159
PDF File Size: 1.30 Mb
ePub File Size: 13.73 Mb
ISBN: 888-6-51681-361-6
Downloads: 60733
Price: Free* [*Free Regsitration Required]
Uploader: Shakalmaran

Press and move to zoom.

Mouse over image to zoom. Premature exposure to ponding water will cause a color change, especially in dark intersela. Typically this would apply to C or D grade rusting in this standard.

INTERSEAL 670HS – PART B (REGULAR) – 0.57L (5.63 :1)

If salt water is used in the wet blast process the resulting surface must be thoroughly washed with fresh water before application of Interseal HS. Dry bristle brushing will normally be adequate for accumulated dirt.

Typical thicknesses will be between milsmicrons. Please consult International Protective Coatings for alternative recommendations.

However, this product is not recommended where thermoplastic coatings such as chlorinated rubbers and vinyls have previously been used. In common with all epoxies Interseal HS will chalk and discolor on exterior exposure. Always mix a complete unit in the proportions supplied.


Loose or flaking coatings should be removed back to a firm edge. Application should then be to a suitably primed surface. Puddles, ponding and accumulations of water must be msda. Once the unit has been mixed it must be used within the working pot life specified. Interseal HS can be used as a non-skid deck system by modification with addition of GMA crushed flint aggregate.

Do not thin more than allowed by local environmental legislation.

Alternatively, a broadcast method of application can be used. With freshly interseaal surfaces a slight degree of flash rusting is allowable, and is preferable to the surface being too wet. However, these phenomena are not detrimental to anti-corrosive performance.

Level of sheen and surface finish is dependent on application method.


A surface profile of mils microns is recommended. Be the first to write a review for this product! Soluble salts should be removed by fresh water washing. Accumulated dirt and soluble salts must be removed.

Certification is for tanks greater than gallons Aged Coatings Interseal HS is suitable ibterseal overcoating a limited range of intact, tightly adherent aged coatings.


Avoid using a mixture of application methods whenever possible. Trowel or roller can be used for small areas. A low VOC, two component high build, high solids surface tolerant epoxy maintenance coating. It is also possible to apply to damp surfaces in some circumstances.


Warning In order to achieve optimum performance on hand prepared steel, the aluminum pigmented version should be applied as a primer coat by brush to ensure thorough wetting out of the substrate by Interseal HS. Systems recommendation Interseal Interzeal will normally be applied to correctly prepared steel substrates. Preferred application is by a suitable large tip hopper gun e. Consult International Protective Coatings for further details.

When applying by methods other than airless spray, the required film build is unlikely to be achieved.

Msdds HS is suitable for overcoating intact, aged alkyd, epoxy and polyurethane systems. Sagola or Air texture gun fitted with a mm nozzle. However, it can be used over suitably primed surfaces.